FAQ
Frequently Asked Questions on the Bolt system
- Bolt 600 – Teradek – Hardware Info – What antennas do I need for the Bolt 600?
- Does the Bolt have video format conversion on the transmitter loop out (SDI/HDMI in to SDI out)?
- Bolt 4K – Teradek – Knowledge – Updating BLE component of Bolt 4K
- Ace 500 - Knowledge - Ace 500 Firmware
- Bolt - Software - Bolt Manager - Clear settings on transmitter
- SmallHD integrated wireless monitors - is pairing possible with Teradek Bolt Manager?
- What are the A/C power requirements for Bolt 4K?
- What power connector and cable pinout is used by the Bolt?
- What is the minimum physical distance for operating multiple Bolt sets?
- Can a Bolt receiver be paired with multiple transmitters simultaneously?
- How many Bolt receivers can be paired with each transmitter?
- Which Bolt models allow manual frequency / channel selection?
- Power & Frequencies of Bolt Units
- Audio Input Specifications on the Bolt product line
- Can I wirelessly convert from SDI input to HDMI output using a Bolt TX and RX?
- Can I convert from HDMI input to SDI output directly on the 2nd or 3rd generation Bolt TX?
- Which Bolt units are capable of sending SDI metadata (time code / record flags)
- How many Bolt receivers can receive time code / record flags at a time?
- What SDI metadata / ancillary data is supported by the Bolt series?
- Tested/supported devices for metadata passthrough
- Which Bolt models have USB 3.0 video capture?
- What are the minimum and maximum ranges for the Bolt?
- Can external / directional antennas be used on the Bolt?
- Is there reverse polarity power protection on the Bolt?
- How do I order a replacement antenna cap for 1st generation Bolt TX units?
- Can the Bolt send a 3D signal over HDMI?
- Bolt FAQ (1st Gen)
- What is the Difference Between Bolt and Cube?