Using DSLR Monitoring Mode on the Cube 2xx to prevent video input loss while recording on a Canon DSLR

BACKGROUND:

The Canon 5Dmk2 changes resolutions when it is switched from Live View to Recording mode. This behavior is also seen on the Canon 60D, T2i and 550D, and other models.

Teradek introduced a feature in Cube's firmware called DSLR Monitoring Mode that prevents this resolution change by only allowing 480p output from the connected DSLR.

SETUP:

1. Connect the Canon's HDMI output directly to Cube's HDMI input
2. In Cube's web menu go to Video Setup -> Device Settings and select Show Advanced Options
3. Turn on DSLR Monitoring Mode; follow the instructions shown in the web page to finish placing Cube in this mode
4. Once Cube reboots, you will be able to record at will and the Canon won't drop the signal to Cube

ADDITIONAL NOTES:

• The Canon's HDMI output should be directly connected to Cube's HDMI input for best results
• You can remove the Canon 5D's camera data from being shown on the HDMI output by pressing the Info button on the camera 3 times
• You can remove the Canon T2i's camera data from being shown on the HDMI output by pressing the Display button on the camera 2 times