Using a 1st generation Cube 2xx with HDMI output from the RED Epic/Scarlet

Issue: The RED Epic & Scarlet output a non-traditional 1080p24 signal over HDMI (e.g. when analyzed through a Marshall monitor the signal is reported as 1080PsF24); Cube 2xx models are not able to encode and stream this variation of the 1080p24 format.

Solution:  Customers with Cube 2xx models should set the RED Epic & Scarlet HDMI output to 720p instead of 1080p24.

Note: Customers with Cube 1xx models are able to use the 1080p24 output over SDI without issue.

Applies to:

1st gen Cube 200 / 220 / 230 / 250